Where can I find the PIN to be entered for the initial setup in the iNet X app?
When the iNet X (Pro) Panel is connected to the iNet X app for the first time, a PIN must be entered.As soon as the
Home / FAQs
When the iNet X (Pro) Panel is connected to the iNet X app for the first time, a PIN must be entered.As soon as the
If you are not using the vehicle, you should always drain the Therme in frosty conditions. To prevent frost damage to the Therme, we advise
This function protects the Combi heater from possible overheating caused by heat build-up. The circulating air motor gives off the possible heat build-up into the
In the setting “Heating without water temperature monitoring” the water in the Trumatic C is also heated automatically when the boiler is full. The
To prevent heat accumulation, no warm air outlets or warm air ducts must be closed off on the Combi 6 (E). With the Combi 4
– Check whether the drain valve in the cold water supply is closed: lever horizontal, position (a). – Open the hot water tap in
Close the drain and aeration valves (4) completely. With premixers Set the control button (2) of the premixer valve all the way to the red
Check the Truma Therme for leaks. If the Therme is leaking, the inside container must be replaced. This can be done by our mobile service
If the caravan is not being used during the frost period, the Truma boiler must be drained as follows: – Disconnect the power to the
If the caravan is not being used during the frost period, the Truma electric boiler must be drained. To prevent frost damage: – Disconnect the