Where can I find the PIN to be entered for the initial setup in the iNet X app?
When the iNet X (Pro) Panel is connected to the iNet X app for the first time, a PIN must be entered.As soon as the
When the iNet X (Pro) Panel is connected to the iNet X app for the first time, a PIN must be entered.As soon as the
Close the drain and aeration valves (4) completely. With premixers Set the control button (2) of the premixer valve all the way to the red
– Check whether the drain valve in the cold water supply is closed: lever horizontal, position (a). – Open the hot water tap in
To prevent heat accumulation, no warm air outlets or warm air ducts must be closed off on the Combi 6 (E). With the Combi 4
In the setting “Heating without water temperature monitoring” the water in the Trumatic C is also heated automatically when the boiler is full. The
This function protects the Combi heater from possible overheating caused by heat build-up. The circulating air motor gives off the possible heat build-up into the
This function protects the unit from possible overheating caused by heat build-up. The circulating air motor gives off the possible heat build-up into the vehicle
At least three outlets of the Trumatic C 4002 must be connected to the warm air distribution to prevent the appliance overheating. However, all 4
Mixed mode of your Combi 6 E heater works like this: On the power selector switch you can select mixed mode 1 or 2. Mixed
Yes, the equipment can be operated without water without restrictions, like all other variants of the Trumatic C heater.
