Can I connect two air conditioners to one iNet X (Pro) panel?
With the iNet X (Pro) panel, one air conditioner can currently be connected. According to the compatibility list , this can be a Truma Aventa roof-mounted
Home / FAQs
With the iNet X (Pro) panel, one air conditioner can currently be connected. According to the compatibility list , this can be a Truma Aventa roof-mounted
Depending on the operating system, the following steps must be performed: Android: Disconnect the panel via the app (App – Settings – Device manager –
When the iNet X (Pro) Panel is connected to the iNet X app for the first time, a PIN must be entered.As soon as the
Close the drain and aeration valves (4) completely. With premixers Set the control button (2) of the premixer valve all the way to the red
– Check whether the drain valve in the cold water supply is closed: lever horizontal, position (a). – Open the hot water tap in
To prevent heat accumulation, no warm air outlets or warm air ducts must be closed off on the Combi 6 (E). With the Combi 4
In the setting “Heating without water temperature monitoring” the water in the Trumatic C is also heated automatically when the boiler is full. The
This function protects the Combi heater from possible overheating caused by heat build-up. The circulating air motor gives off the possible heat build-up into the
At present, we cannot offer Truma boilers that are approved for boats. Remember that the approval and warranty become invalid if you install a Truma
No. Approvals for fixed buildings have changed so that Truma water systems cannot be installed in mobile homes. Our appliances are approved for recreational vehicles.