Error 621 appears in the display of the CP plus panel – what should I do?
Error 621 appears in the display of the CP plus panel – what should I do? This error is displayed flashing during the first commissioning
Error 621 appears in the display of the CP plus panel – what should I do? This error is displayed flashing during the first commissioning
Remedy fault 507 / 516 / 517 (gas supply interrupted) Restore the gas supply, for example by connecting a full gas cylinder. Then confirm or
The heater does not have 12 Volt power supply or there is no connection between the heater and the CP plus control panel. The power
Combi E in mixed mode (combined gas and electric heating operation): Warning indicates lack of gas supply. The heater now only runs in electric mode.
Your heater includes a window switch which prevents the heater from starting up if the side window above or right next to wall cowl of
This function protects the unit from possible overheating caused by heat build-up. The circulating air motor gives off the possible heat build-up into the vehicle
At least three outlets of the Trumatic C 4002 must be connected to the warm air distribution to prevent the appliance overheating. However, all 4
Mixed mode of your Combi 6 E heater works like this: On the power selector switch you can select mixed mode 1 or 2. Mixed
Detailed information about the fault codes, their cause and how to fix them can be found in the Operating and Installation Instructions of the Truma CP
There are many reasons why your Truma air conditioner may not respond to commands from the remote control: Check whether there are any obstructions
