Combi 6 E

Combi heater

Combination heater with integrated heating elements for large vehicles

  • With integrated heating elements: runs in gas, electric or mixed mode

  • Fast, even water heating in a very short time

  • Very low power consumption

  • Lightweight and compact, allowing various installation options

  • In hot water mode, water can be heated independently of the space heater

  • New: Up to 25% faster heating of the interior

  • New: More hot water

More details about Combi 6 E

Combi 6 E is a warm air heater with integrated hot water generator. It’s different from Combi 6 due to its integrated electric heating elements. These allow you to run the heater in gas, electrical or mixed mode. For stationary use at camp sites, you can run the Combi heater with the 12V power supply unit without the vehicle battery.

All you have to do is set your preferred temperature on the digital control panel and leave the rest to the powerful fans in the Combi 6 E. They distribute warm air evenly throughout the vehicle through four air outlets. If the water tank is filled, water is heated at the same time. In summer, you can heat just the water without using the space heater. At temperatures below approx. 3 °C, the FrostControl drain valve opens and automatically drains the tank. The water is drained intermittently so that the drain doesn’t freeze.

Combi 6 E is not only powerful and economical, it can also be installed flexibly in any vehicle and requires little space.

  • Intuitive operation of Combi 6 E with the digital CP plus iNet ready control panel
  • Automatic climate control possible in combination with a Truma air conditioner
  • FrostControl drain valve integrated (requires no electricity)
FAQs
Downloads
Videos
{{filteredFaqs.length}} FAQ
{{filteredFaqs.length}} FAQs

Download List

{{amountDownloads}} Download
{{amountDownloads}} Downloads

Service Videos

{{filteredVideos.length}} video videos

{{video.title}}

The video was not found.

Accessories

Find suitable accessories.
Awning warmer Directs the warm air from the existing caravan heater directly into the awning. If more heat is required, a second awning warmer can be installed.
Surface-mounted frame CP plus For installation of the digital CP plus iNet ready control panel in caravans or motor homes, if the control panel cannot be flush mounted in the wall.
FrostControl heating element for Combi heaters When the heater is switched on, the heating element quickly warms to ten degrees Celsius. Consequently, the water container can be filled regardless of the room temperature. Complete with 1.5 m cable.
Optimum warm air distribution Precisely coordinated modular system. Ensures even, comfortable heat distribution throughout the interior.
Cowl extension KVC for Truma Combi heaters Prevents the heater flame extinguishing in case of strong winds or a lot of snow. For caravans and motor homes. Length: 30 cm